FocusHacks Home Home
All Hacks

Zetec Engine
SPI Engine
General
Suspension

Interior
Exterior
In-Car-Entertainment
Detailing and Cleaning

Maintenance
Miscellaneous

Airbox Resonator Removal

It's debatable whether this Hack does much for performance, but it adds a nice sound to the engine under load.

Tools:
Flat-head Screwdriver or 10mm socket with extension
Time Required:
About 45 Seconds :)
Procedure:
1) Open the hood.
2) Locate Airbox.  Towards the driver's side fender you'll see a small box attached to it.  That's the
   resonator. We're taking that guy OFF! 3) Using a screwdriver or socket, loosen the 2 screws on the airbox that are closest to this Resonator. Three
   turns ought to do it. 4) Pull up on the airbox. 5) Pry the resonator away from the airbox. 6) The lower part will still be connected. Pull the lower part of the resonator firmly away from the airbox
   until it pops out. 7) Observe the new air entrance point! 8) Tighten the screws you loosened. 9) Start the car and rev it. Hear the difference! 10) Close everything up. * Note: For North American Foci, this applies only to 8v 2.0L SPI and 16v 2.0L Zetec-E engines. This excludes the 16v 2.3L Duratec (PZEV)

comments powered by Disqus